Baseboard Heater Accessories
Inside 90° Corners
Use these baseboard heater accessories when two heaters meet at an INSIDE 90° angle (points away from the room).
Available in:
Measuring Notes
Remove endcaps. Measure side 1 from pipe to corner. Subtract 3'' for depth of the adjacent cover. Repeat with side 2. Learn MoreOutside 90° Corners
Use these baseboard heater accessories when two heaters meet at an OUTSIDE 90° angle (points into the room).
Available in:
Measuring Notes
Measure from the far end of the application to the point where the two walls meet at the outside corner. Note: There is no need for deducting 3” from the measurement since the outside corner piece attaches differently than the inside corner piece. The outside corner piece will extend beyond where the walls meet and clip to the end of the panels. Learn MoreInside 135° Bay Window Corners
Use when two heaters meet at an INSIDE 135° angle (points away from the room). Common for heaters placed inside a set of bay windows.
Available in:
Measuring Notes
Remove endcaps. It is best to measure from where the front plates meet. Usually located 2.5"-3" in front of the back plate. Bay window corners demand the greatest accuracy as there is little "play" in getting more span from these accessories. Learn MoreOutside 135° Bay Window Corners
Use when two heaters meet at an OUTSIDE 135° angle (points into the room). Common for heaters placed on the outside edge of bay windows.
Available in:
Measuring Notes
Remove endcaps. Measure from the far end of the application to the point where the two walls meet at the outside corner. Note: There is no need for deducting 3” from the measurement since the outside corner piece attaches differently than the inside corner piece. The outside corner piece will extend beyond where the walls meet and clip to the end of the panels. Learn MoreClosed Endcap (Right/Left)
Used when the copper pipe bends down into the floor or into the wall behind the heater.
Available in:
Measuring Notes
An endcap allows you to adjust your total length an additional 1.75”. A pair of endcaps can offer a full 3.5″ of additional span to the overall length of coverage on a typical straight heater. Endcaps require a minimum of 0.5” clearance from an adjacent wall.View Video
Open Endcap (Right/Left)
Used when the copper pipe continues straight through an adjacent wall.
Available in:
Measuring Notes
An endcap allows you to adjust your total length an additional 1.75”. A pair of endcaps can offer a full 3.5″ of additional span to the overall length of coverage on a typical straight heater. Endcaps require a minimum of 0.5” clearance from an adjacent wall.View Video
Zero Clearance Endcap
When standard endcaps won't fit. Used when the original back plate terminates less than 0.5" from the adjacent wall.
Available in:
Measuring Notes
If the backplate terminates less than 0.5" from an adjacent wall, a Zero Clearance Endcap is required. Each Zero Clearance Endcap can add up to 1” to the overall span.View Video
Coupler
Couplers join two panels together for longer lengths. They overlap, and hide, the seam that two panels create when they are butted up together.
Available in:
Measuring Notes
Baseboard heaters longer than 7′ (6′ for Basic series) will require the use of multiple panels and couplers to register the ends together.Wall Brackets
Typically used when the original back plate has been removed, when the original back plate is less than 7.5" in height (less than 9.5" for Premium Tall), or in new construction environments.
Available in:
